Just got my new Blast and I am a bit confused about the bridal settings any TIP`s.
Blast settings
Started by flyer, May 24 2006 11:32 AM
2 replies to this topic
#2
nckiter
-
- Forum Member
-
- 119 posts
Occasional Poster
- Gender:Male
- Location:Apex, NC
Posted 24 May 2006 - 12:38 PM
Hello flyer,
You probably want to remove the down line between the upper and lower bridles. The lower bridle should connect to both vertical spars. I would suggest starting with the outsice position on the lower bridle. Other than that the only adjustments should be at your handles. Enjoy your new kite! It is appropriately named!
You probably want to remove the down line between the upper and lower bridles. The lower bridle should connect to both vertical spars. I would suggest starting with the outsice position on the lower bridle. Other than that the only adjustments should be at your handles. Enjoy your new kite! It is appropriately named!
Kip Clement
Apex (land of light and variable wind) NC
Apex (land of light and variable wind) NC
#3
flyer
-
- Forum Member
- 6 posts
Posted 24 May 2006 - 02:31 PM
Thanks for that.
I will try your recomendations.
At the moment it feels that I am flying on the break lines only :?:
I will try your recomendations.
At the moment it feels that I am flying on the break lines only :?:
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
