I'm looking for the standard measurements for the Rev 1.5 SUL bridle, I think that mine is a bit off.
Cheers
Mario
Rev 1.5 SUL bridle measurements
Started by mdilucca, Apr 24 2007 03:23 PM
1 reply to this topic
#1
mdilucca
-
- Forum Member
-
- 346 posts
Regular Poster
- Gender:Male
- Location:Victoria, BC, Canada
Posted 24 April 2007 - 03:23 PM
Cheers
Mario
#2
RevWizard
-
- Forum Admin
-
- 3,289 posts
Rev Guru and Historian
- Gender:Male
- Location:Europe & North America
Posted 24 April 2007 - 09:48 PM
I would suggest that you equalize the two sides.I'm looking for the standard measurements for the Rev 1.5 SUL bridle, I think that mine is a bit off.
Cheers
Mario
With the spars removed. Match up each side and see if there are any differences. If you don't have any differences, then your bridle is most likely ok.
If you have a difference, try to determine which side moved and correct it. If you can't determine which side, either compare it to another REV 1.5 with the same type of bridle or worse guess at it. They need to be the same measurements. I would say 5mm(roughly 1/8inch) tolerance is good enough.
Long John (formerly Mr. R)
STACK International Executive Committee - 6/1996-6/2008
International Rules Book Committee and STACK International Head Judge - 6/2004-6/2008
World Sport Kite Championship Judge - 2004-2005-2006(Chief Judge)
13x 1st - 12x 2nd - 6x 3rd places in 37 overall Quadline individual competitions
NEWLY REVISED Web Site - http://www.johnnmitchell.com Check it out today!
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
